Out of stock
Carburator Weber 32 DIR
Spare parts for Weber 32 DIR carburetor
Are you looking for quality parts to maintain or repair your Weber 32 DIR carburetor? At AVP – Arnaud Ventoux Pièces, we offer a wide selection of components perfectly suited to the Weber 32 DIR, designed to optimize performance and ensure the durability of your carburetion system.
Our parts for Weber 32 DIR:
- Air Intake: High-performance air filters, intake socks, and mesh filters for Weber 32 DIR air horns, allowing for better airflow while effectively filtering out impurities.
- Carburetion: High-precision jets, bowl gaskets, needle valves, and mixture adjustment screws to precisely adjust the air/fuel ratio and ensure optimal engine operation.
At AVP – Arnaud Ventoux Pièces, we provide you with all the essential parts to ensure quality maintenance of your Weber 32 DIR carburetor, in order to maximize its performance and extend its lifespan.
In stock
Out of stock
Out of stock
Mounting center distance (Width): 48.5mm
Mounting center distance (Length): 92mm
Thickness: 5mm
In stock
In stock
Stem length: 38mm
Center distance of the membrane holes 27mm
In stock
In stock
In stock
Stem Length: 37mm
Diaphragm hole spacing: 35mm
In stock
In stock
In stock
In stock
Suitable for WEBER 40DCOE and 45DCOE carburetors
M5x32 screw
Head width 8mm
Number 52 on exploded view
Compatible with other WEBER carburetors, see below
In stock
In stock
In stock
In stock
Idle speed adjustment screw spring for WEBER 40DCOE and 45DCOE
sold individually, ,eed 2 pieces for one carburettor
Part number 47 on the exploded view
Fits other WEBER carburettors, see below
In stock
In stock
Fuel pressure gauge kit.
Allows fuel pressure adjustment with the "King" filter REF 6825.
Graduation from 0.20g up to 1 bar.
With connector and clamp for 6 or 8 diameter flexible hoses.
The pressure gauge can be...
In stock
Allows easy adjustment of the float with one side of the tool calibrated to 5mm and the other to 6mm.
Allows direct action on the float tab thanks to a slot at the end of the tool
In stock
Allows easy adjustment of the float with one side of the tool calibrated to 8mm and the other side to 9mm.
Allows direct action on the float tab thanks to a slot at the end of the tool.
In stock
Allows control of nozzle calibration
Graduation is 0.05 mm in 0.05 mm increments, with a minimum of 0.45 mm and a maximum of 1.5 mm.
In stock
Allows control of nozzle calibration
Graduation is 0.10 mm in 0.10 mm increments, with a minimum of 1.5 mm to 3.00 mm and a maximum of 1.5 mm.
In stock
Synchronizer/Synchrometer to be placed directly in the air intake horn for timing adjustment
Suitable for all AVP air intake horns
Graduation from 1-30kg/h
In stock
Sold with drill bit holderIncludes 5 drill bits in each of the following sizes:0.6mm0.7mm0.8mm0.9mm1.0mm1.1mm1.2mm1.3mm1.4mm1.5mm1.6mm1.8mm2.0mm2.1mm2.2mm2.3mm2.4mm2.5 mm2.6mm2.8mm3.0mm3.2mm
In stock
In stock
This paste is suitable for petroleum-derived hydrocarbons (mineral oils, petroleum, fuel oil, leaded and unleaded gasoline, etc.), chlorinated solvents, diluted acids and bases
Replaces or is used in combination with...
In stock
In stock