Carburator Weber 32 DARA
Spare parts for Weber 32 DARA carburetor
Are you looking for replacement parts to maintain or restore your Weber 32 DARA carburetor? At AVP – Arnaud Ventoux Pièces, we offer a complete selection of components specifically designed for the Weber 32 DARA, to optimize the performance and longevity of your carburetion system.
Our parts for the Weber 32 DARA:
- Air Intake: High-performance air filters, intake sleeves, and mesh filters for Weber 32 DARA air horns, ensuring optimal airflow while removing harmful debris.
- Carburetion: Precision jets, bowl gaskets, needle valves, and mixture adjustment screws to ensure precise control of the air/fuel mixture and maximize fuel efficiency.
At AVP – Arnaud Ventoux Pièces, we provide all the parts you need to guarantee the performance and reliability of your Weber 32 DARA carburetor, ensuring you an optimal and long-lasting driving experience.
Out of stock
In stock
Suitable for WEBER 40DCOE and 45DCOE carburetors
M5X22 screws
Sold individually, requires 9 pieces for one carburetor
Number 5 on exploded view
Compatible with other WEBER carburetors, see below
In stock
In stock
In stock
In stock
In stock
In stock
Idle speed adjustment screw spring for WEBER 40DCOE and 45DCOE
sold individually, ,eed 2 pieces for one carburettor
Part number 47 on the exploded view
Fits other WEBER carburettors, see below
In stock
In stock
Fuel pressure gauge kit.
Allows fuel pressure adjustment with the "King" filter REF 6825.
Graduation from 0.20g up to 1 bar.
With connector and clamp for 6 or 8 diameter flexible hoses.
The pressure gauge can be...
In stock
Allows easy adjustment of the float with one side of the tool calibrated to 5mm and the other to 6mm.
Allows direct action on the float tab thanks to a slot at the end of the tool
In stock
Allows easy adjustment of the float with one side of the tool calibrated to 8mm and the other side to 9mm.
Allows direct action on the float tab thanks to a slot at the end of the tool.
In stock
Allows control of nozzle calibration
Graduation is 0.05 mm in 0.05 mm increments, with a minimum of 0.45 mm and a maximum of 1.5 mm.
In stock
Allows control of nozzle calibration
Graduation is 0.10 mm in 0.10 mm increments, with a minimum of 1.5 mm to 3.00 mm and a maximum of 1.5 mm.
In stock
Synchronizer/Synchrometer to be placed directly in the air intake horn for timing adjustment
Suitable for all AVP air intake horns
Graduation from 1-30kg/h
In stock
Sold with drill bit holderIncludes 5 drill bits in each of the following sizes:0.6mm0.7mm0.8mm0.9mm1.0mm1.1mm1.2mm1.3mm1.4mm1.5mm1.6mm1.8mm2.0mm2.1mm2.2mm2.3mm2.4mm2.5 mm2.6mm2.8mm3.0mm3.2mm
In stock
In stock
This paste is suitable for petroleum-derived hydrocarbons (mineral oils, petroleum, fuel oil, leaded and unleaded gasoline, etc.), chlorinated solvents, diluted acids and bases
Replaces or is used in combination with...
In stock
In stock
In stock
In stock
In stock
In stock