Best sellers
For original "Turbine" finned and full "Bobine" rims
Ø recess 68mm
In stock
In stock
In stock
Out of stock
In stock
In stock
Suitable for:
R8 (All models) / Caravelle / Floride S
A110 (All models) / Alpine GT4
A310 V6 (Left side boot)
Matradjet
In stock
Suitable for:
R5 Alpine Atmo (1223) with prepared camshaft and engine
R5 Alpine Turbo (122B)
R5 Turbo (8220)
Possibility of mounting the pushrods in a naturally aspirated engine (R5 Alpine) by adjusting the pushrod...
In stock
Out of stock
In stock
Fan trigger temperature 82°C
Fan stop temperature 72°C
In stock
Suitable for:
R5 Alpine Turbo (122B) and R5 Alpine Coupe / GR2: Rear Brake
R12G: Rear Brake
R17TS / R17G: Rear Brake
In stock
Suitable for:
R5 Alpine Atmo (1223) with prepared camshaft and engine
R5 Alpine Turbo (122B)
R5 Turbo (8220)
Possibility of mounting the pushrods in a naturally aspirated engine (R5 Alpine) by adjusting the pushrod...
In stock
In stock
In stock
In stock
To turn on a temperature warning light
Trigger temperature 105°C
In stock
In stock
In stock
In stock
Out of stock
In stock
Suitable for the following gearboxes:
Box 330 (3rd)
Box 352-10 / 352-11 / 352-13 / 352-30 / 352-31 / 352-33 (3rd, 4th)
Box 353 (3rd, 4th, 5th)
Box 364-05 / 364-06 (3rd, 4th, 5th)
Box 365-10 / 365- 14 / 365-20 /...
In stock
In stock
In stock
Length taken from the axis of the upper fixing bolt to the support of the 1st washer: 10.5cm
In stock
In stock
In stock
In stock
In stock
Thickness: 1.80mm
Width: 17.75mm
In stock
In stock
For diaphragm clutch mechanism
In stock
In stock
In stock
Suitable for:
R8 / A110: Front Brake (Big Brake Assembly)
R5 Alpine Atmo (1223) and Alpine Turbo (122B): Front Brake
R12 (All models) / R15TL: Front Brake
R16(L / TL / TS ) / R16TX (2nd assembly): Front Brake...
In stock
For engine with 1 outlet water pump.
Kit sold without valve stem seals (AVP1012), without copper base seals and without the timing case oil seal (AVP1029).
In stock
In stock
In stock
In stock
Out of stock
In stock
In stock
Sold with 3 fixing screws and the oil seal (Ø 17x30x7mm)
Guide to be mounted when replacing a clutch with a graphite thrust bearing with a modern diaphragm clutch
It is necessary to drill and tap in the clutch bell...
In stock
Diaphragm Ø: 75mm
Diaphragm hole spacing: 62mm
Diaphragm rod height: 34mm
In stock
Out of stock
In stock